How To Use Coax Crimper

Download Article

Download Commodity

Coaxial cable, commonly referred to as coax, is an electronic signal wire used for signals that are sensitive to interference by outside noise sources. For instance, lightning, clear air static, motors and loftier frequency electronic signals could impose themselves on the wire and corrupt the signal. Coax guards against this by wrapping a single conductor with a tube of metal foil and mesh. This tube runs coaxially over the signal conductor. Maintaining the integrity of this shielding tube requires a special crimp termination method for coax. Use these tips to learn how to crimp coax.

Steps

1
Create a termination bespeak.
- Cutting off the terminate of the coax. Use small, sharp wire cutters. Create a squared off surface, rather than a beveled surface.
- Mold the end of the coax using your fingers. The cylindrical cable will be distorted past the pressure of making the square cut. Mold the end of the cable back into a cylinder.
2

Insert the coax into a coax stripper tool. These tools are available at hardware and electrical stores. Make certain that the finish of the coax is flush against the wall or guide on the stripping tool. This will ensure proper strip length.

Advertisement
3

Clamp the stripper tool closed effectually the coax. Smoothly spin the tool around the coax 4 or v times, or until yous no longer hear the sound of metallic being scored. Keep the rotation in one identify on the cable. Do not apply any force that would pull on the cable insulation blanket.
4

Remove the coax stripper tool. The tool will accept made two cuts. Use your fingers to gently pull off the material nearest the finish of the cable. This will expose the bare eye conductor. Utilise your fingers to gently pull off the outer insulation that has been cut free. This will expose a layer of foil.
5

Tear off the exposed foil. This will expose a layer of metallic mesh.
6

Curve back the exposed metallic mesh with your fingers. Practise not tear the layer of foil that is nether the metal mesh. The foil must be left in place around the inner insulation. Bend the mesh all the way back so that it is molded over the end of the outer insulation.
7

Press the end of the coax into the dorsum of an F connector. F connectors are available at hardware and electric stores. Make sure that the white inner insulation tin be seen pressing against the front end flange of the connector. If you tin can't encounter the insulation, jiggle and continue to push the coax and the connector together. Utilize straight pressure level only. Do non twist the coax in the body of the connector.
8

Crimp the connection. Place the F connector into a coax crimping tool. Coax crimping tools are available at hardware and electric stores. Fully squeeze the tool handle and release. Remove the finished crimp connexion from the tool.